We offer a wide range of accessories for our chucks. Further below you will find frequently required adapters and jaws. However, the requirements set by the various applications are very different and cannot always be covered by a standard program. Therefore Koch Maschinenbau supports you with the design of the adapter or special jaws or takes over the design and manufacturing completely. On the page special chucks you will find more information.
Fixtures / Adapters
Cylindrical fixture (standard fixture)
Morse fixture MK2 (incl. forcing nut)
Flat adapter
Adapter for zero point clamping system 3R
Adapter for zero point clamping system Erowa
Adapter for zero point clamping system Hirschmann PrisFix
Clamping Jaws
Standard jaws, made of hardened stainless steel*
* Please note that we do need the chuck in which the jaws will be used in-house, if the jaws are subsequently ordered or repaired. The jaws must be ground over in the chuck in which they will be used. Otherwise, a high accuracy cannot be achieved.
Base jaws made of hardened stainless steel
* Due to the small jaw size of the DBF34, it is hardly possible to provide a general base jaw that can be used for as many applications as possible. Please contact us to find a suitable solution for your application.
** The jaw guides for the DBF55 and DBF63 or the DBF160 and DBF200 are identical. Therefore, one type of base jaw is used for both chucks. Please note that the base jaws of the DBF55 are slightly longer than the standard jaws of this chuck type.
The base jaws are designed in a way that only two fitting holes with through-going screws are required for adaptation. We recommend that you use the "Full top jaws, made of brass" drawings below as a guide when designing your own top jaws.
